Stereo Active DI Box Rock and Roll Electric Guitar Electric Bass Box

parameter

Bottom sliding pad treatment, providing physical mechanical isolation and electrical insulation

Equipment type: proprietary analog circuit

Number of channels: single sound channel

Audio circuit type: proprietary analog circuit with low-noise operational amplifier

Number of channels: 1

Frequency response: 20Hz~20kHz

Dynamic range: 109 decibels, 109 dB

Total harmonic distortion: 0.002% @ -5dBu

Intermodulation distortion: 0.003% @ -3dBu

Phase deviation:+10o at 20Hz | 0o at 1kHz | -1o at 20kHz

Input impedance: 220k -? Input 220k unbalanced, 1/4 inch

Output impedance: 600 - XLR output 600 XLR balanced

Equivalent input noise: -103dBu

Noise: -99dB below 0dBu -99dB below 0dBu

Large input:+10dBu

Input level:+10dBu

Input interface: 1 x 1/4 inch straight through

Output interface: 1 x XLR balanced

characteristic

Input board, 180 polarity reversal, grounding raised, HPF

Input connector: 1x 1/4 "in and thru

Output connector: 1 XLR

Construction: 14 steel chassis and shell

Weight: 1.55 pounds (720 grams) 0.72Kg

Power: 48V Phantom - Exclusive Digital Switching

Condition: Only applicable to dry places between 5 C and 40 C

function

15dB PAD: It can attenuate the input level of the front-end equipment by a fixed value of 15dB.

48V Check: Used to check whether the DI box is powered on, it needs to be used in conjunction with LOW CUT. When LOW CUT is pressed, the light flashes once to indicate that power has been supplied.

MERGE: Signal merging function, normally INPUT is used as the signal input, THRU is used as the parallel signal output. After pressing the switch, both interfaces can be used to input LR stereo signals and mix them into mono mono signals for output from Canon.

Ground: A selection switch for disconnecting and grounding, which can solve the noise problem caused by two devices on the power or grounding circuit.

LOW CUT: In addition to detecting power supply, it can perform a low cut of 80Hz-6dB on the signal.

Polarity reversal: The signal can be reversed 180 degrees in polarity, that is, reversed.

What's in the box
1xDI BOX
1xPackaging box
1xBOX CASE
1xInstructions