This DIN rail mounted POE surge protector is an essential lightning protection accessory for POE IP cameras, network switches, routers and all gigabit POE network equipment, widely used for outdoor monitoring, factory wiring, commercial office and home security systems.
Designed for standard 48V DC POE supply, it fully supports 100/1000M gigabit network transmission with ultra-low insertion loss 0.2dB, which will not cause network lag, signal attenuation or data loss during surge protection. With ultra-fast 1ns response time, it instantly absorbs lightning surges and induced overvoltage to block damaging electric current before it reaches your expensive network devices.
Boasting strong surge bearing capacity, the nominal discharge current reaches 2.5kA and maximum discharge current up to 5kA, providing reliable all-8-core wire protection for RJ45 ethernet lines. The standard DIN rail mounting design allows quick snap-on installation on electrical cabinets without extra tools, saving much wiring time.
The solid white flame-retardant housing adapts to harsh working conditions, stably operating at -40 to +70 under relative humidity below 90%, perfectly fitting outdoor monitoring equipment exposed to thunderstorms. Equipped with clear IN/OUT RJ45 ports and dedicated grounding terminals, the wiring logic is intuitive for electricians and DIY installers.
Lightweight compact size (76×52×25mm, only 70g) takes minimal cabinet space. It effectively prevents expensive IP cameras and network hardware from burning out during thunder weather, greatly cutting your equipment maintenance and replacement cost. If you run outdoor POE surveillance systems, this gigabit POE lightning arrester is a cost-effective must-have protective gear to extend your device service life.
What's in the box
1 x Surge Protector
