Product introduction: The module uses for 's new BMI160 6- inertial motion sensor in a MEMS sensor package that integrates the top 16-bit 3- accelerometer with an ultra-low-power 3- gyroscope.
The module can output acceleration data (acceleration values detected by the device in the X, Y, and Z directions) and gyroscope data (the speed at which the device rotates around the X, Y, and Z axes). When accelerometers and gyroscopes operate in full-speed mode, typical power consumption is as low as 950 A, which is only 50% or less of the power consumption of similar products on the market.
Designed for smartphones, tablets, and wearable devices, for the BMI160 includes a built-in smart step counter algorithm that reads the number of steps directly through the registers.
The built-in 3- acceleration and 3- gyroscope enable motion detection such as running and fitness. Module built-in power management chip, VIN supports 3.2~6V wide voltage supply, also has a separate 3.3V interface, compatible with for 3.3V and 5V controller direct drive.
Application scenario:
1. Walking step
2. Acceleration detection
3. Dip measurement
4. Display switch horizontal / vertical mode
Technical specifications:
Working voltage: 3.2V~6V
Current consumption: Less than1mA
Interface mode: 2.54 pitch pin header
Acceleration optional scale: 2g/ 4g/ 8g/ 16g
Gyro optional scale: 125 /s, 250 /s, 500 /s, 1000 /s, 2000 /s
Accelerometer zero drift: 40mg
Gyro zero drift: 10 /s
Programmable frequency: 25/32Hz~1600Hz
6D detection and positioning
16-bit data output
Impact resistance: 10, 000 gx 200 s
2 programmable interrupt generators
Built-in 1024
Working temperature: -40 C ~ +85 C
Material: PCB
colour: As Shown
Package Contents:
10 set Accelerometer Sensor Module
Only the above kage content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
What's in the box
10 set Accelerometer Sensor Module
